Equipment: |
Shaula equipment list
2014-2017 Garmin chart plotter radar package Ablative paint removed, hard paint applied Depth sounder installed Water pressure system with 5 gallon hot water tank. Vitrifrgo cold plate/compressor installed into icebox- AC/DC powered. Hard dodger installed
2018-2021 Rig refit 2020- mast removed, compression post added inside cabin, new electrical conduit in mast, new electrical, internal halyards added, standing rig inspected (from 2006) boom inspected and internal reef lines, clutch and winch added. Prop and shaft removed and inspected Dripless PSS shaft seal installed New jib- 90 percent approx. High clew. Staysail gone over and edges reinforced Profurl furler Beta 25 engine installed Pelagic tiller pilot Garmin wind instrument installed at masthead Thru-hull for sink sea water added Dickinson bulkhead diesel heater Marine mattresses for vberth
2022-2024 Major refit summer/winter of 2022-2023 Deck stripped if glass, rot in deck and beams removed and glass layed over deck and hull joint, new cockpit foot well built, bulkhead built under cockpit locker, box built over engine, new chain plates, new stem fitting, bowsprit recoated. Deck and hull sanded, primed and painted. Interior paint stripped and recoated. Varnish on wood surfaces. New overhead foam installed throughout cabin. Iridium Go with external antenna 6 person liveraft- recertified New batteries- Dyno 6v deep cycle X4 with 12v to 12v charger plus new shore power charger Monitor wind vane setup on bumkin struts New strong track added to mast New full batten offshore mainsail from Port Townsend Sails Diesel tanks removed, cleaned, and inspected. Overboard pump out setup installed. Solar panels installed- 2x 175 Amps rigid panels on stern rail. 2x 100 Amps flexible panels on dodger. Separate Victron charge controllers. Katadyn Power Survivor 40e watermaker Garmin AIS added to NMEA 2000 network. ACR epirb Lee cloths added to main cabin upper settees
Victron 800w Inverter Ice maker |